WARNINGS!!

Any DIY repairs will void the warranty. There is potential DANGER ... [Read Me First]

Home > AV receiver/Home Theatre > No sound from JVC TH-M303 Home Theatre System

No sound from JVC TH-M303 Home Theatre System

June 7th, 2009 Leave a comment Go to comments

Symptom: The TV has pictures, the light on the subwoofer stays on, but no sound from any speaker.

 

No sound problem could be caused by many defective parts. In this case, it’s an open R2702. This open resistor fuse cuts off the power to AMP and causes no sound.

 

Remedy: replace R2702  (47OHM, 1/4W).

 

This resistor is located in the subwoofer. Remove the screws on the back and bottom of the subwoofer, slide out the AMP assembly a little, disconnect the woofer’s wires, and then you can take out the AMP assembly totally. The picture below shows the location of the resistor.

jvc-th-m303-no-sound

 

Categories: AV receiver/Home Theatre Tags:
  1. James Blatz
    November 30th, 2009 at 14:11 | #1
    Reply | Quote

    My JVC TH M303 has no sound from the subwoofer but all aother speakers work OK. Occasionaly the amp (sound) seems to reset itself when the cable from the subwoofer to the master unit is disturbed. Any suggestions?

  2. Ty
    November 16th, 2010 at 14:20 | #2
    Reply | Quote

    @James Blatz
    I have the EXACT same problem. Did the article fix your problem?

  3. sherry carlisle
    July 12th, 2011 at 10:32 | #3
    Reply | Quote

    can i fix it my self

  4. sherry carlisle
    July 12th, 2011 at 10:56 | #4
    Reply | Quote

    Where can I get the R2720(47OHM)14W

  5. sherry carlisle
    July 12th, 2011 at 11:00 | #5
    Reply | Quote
  6. sherry carlisle
    July 12th, 2011 at 11:03 | #6
    Reply | Quote
  7. sherry carlisle
    July 12th, 2011 at 11:09 | #7
    Reply | Quote

    what can i do change the cord?